Snomax summer storage is the manufacturer’s procedure for preparing a Snomax injection system for the off-season. According to Snomax, a system that is properly cleaned and serviced when the season ends will start without problems the following winter. The procedure is an 11-step checklist, also available as a printable service instruction card.
What it includes
- Tank cleaning: removing mud and debris with a strong water jet, scrubbing with a coarse brush and a biodegradable cleaner, rinsing and refitting the cleaned filter.
- Disinfection: running a 10 % bleach solution through the mixing and injection pumps at full power until the tank is empty, then flushing with clean water.
- Mixing pump care: draining the pump and filling its grease cup with biodegradable grease up to the red line.
- Injection pump care: changing the pump oil.
- Frost protection: pouring 7.5 l (2 gal) of biodegradable antifreeze into the calibration tube with the pump running, and stopping the pump just before it runs dry.
- Closing all drain lines and the tank cover to keep pests out.
How it works
The steps are carried out in order at the end of the season. Snomax recommends leaving the antifreeze in the lines and the pump head until just before snowmaking resumes: this protects them on unexpected frost days and, according to the instruction card, keeps the diaphragm from stretching and the check valves from sticking. The bleach solution must never stay in contact with the pump’s stainless steel or aluminum parts for more than 12 hours, because longer exposure can severely damage the pump.